Unified image
Two radios, PoE and a front panel.
Good for
- Two channels at once
- PoE mounting, left running unattended
- Using front-panel menus without a phone
Hardware
| Part | Detail |
|---|---|
| Processor | Raspberry Pi Compute Module 4 (BCM2711) |
| Memory | 8 GB on the tested unit. A CM4 comes with 1, 2, 4 or 8 GB; check which one your Pro has |
| Wi-Fi | Two Intel BE200 on PCIe |
| Wi-Fi card link | Both cards share the CM4’s single PCIe 2.0 ×1 lane (5 GT/s, about 4 Gb/s) |
| Storage | Removable SD on the tested unit; check yours before writing |
| Wired | Gigabit Ethernet with PoE in |
| Power | PoE or USB-C. A battery keeps it running after external power is removed |
| Display | OLED front panel with five buttons |
What you can buy
- Compute module: CM4 with 1, 2, 4 or 8 GB of memory, and no eMMC (Lite) or 8, 16 or 32 GB. The tested Pro has 8 GB and boots from SD, which means a CM4 Lite. Check yours before writing the image.
- Storage: SD on a CM4 Lite, or the CM4’s eMMC. SD write speed depends on the card.
Radios
| Card | Measured |
|---|---|
| Two Intel BE200 | On separate channels at once. The card captures at 320 MHz on a Gen2 link (tested on a NanoPi, same card and link type); the app offers up to 160 MHz today |
Limits
- Heat: in a one-hour run the two radios reached 86 °C and 91 °C.
- Both radios share one PCIe 2.0 lane (5 GT/s), so their combined rate is capped at about 4 Gb/s before overhead.
Measured
- One-hour capture on both radios: about 3.0 and 3.2 million packets, no drops.
Install
The tested Pro uses removable SD. Check your unit's storage before writing. Its carrier board selects the Pro front panel and button profile. Use supported power or PoE, and remember the battery can keep it powered after external power is removed.
Then follow the unified image setup guide: claim the sensor with its one-time code, and connect from the app or the device website.