WLAN Commander — XIAO ESP32-C5 sticker-antenna enclosures
Print files dated September 10, 2026; published September 11, 2026.

Model: Seeed Studio Xiao esp32 c5 sticker antenna case
Creator: DodgeZ
Source: https://makerworld.com/en/models/3292004-seeed-studio-xiao-esp32-c5-sticker-antenna-case#profileId-3735441
License: Creative Commons Attribution 4.0 International
https://creativecommons.org/licenses/by/4.0/
The MakerWorld listing displayed this creator and license on September 11, 2026.

These 25 3MF files are unmodified copies from the model owner's supplied folder.
Paired project filenames have been shortened for downloads; file contents are unchanged.
The superseded "PETG test" project is not included.

Start with 3x-magsafe-base-and-cap-petg.3mf for the pictured three-board build.
*-and-cap-petg.3mf: paired Bambu Studio projects with both pieces and PETG settings.
Other 3MF files: geometry only, without the paired projects' printer settings.
1x/2x/3x denotes the number of XIAO ESP32-C5 boards.
Choose the regular or matching MagSafe family for BOTH the base and cap.
*-base-with-thruhole.3mf is an alternative base for pre-soldered header pins.
coupon-base.3mf and coupon-cap.3mf form a small USB-end fit sample.

The five paired projects target Bambu Lab X1 Carbon, 0.4 mm nozzle, textured PEI,
PETG Basic, 0.2 mm layers, 4 walls, 5 top/bottom layers, 25% gyroid, no supports/brim.
Check your printer, filament, plate and slice before printing. These are project/model
files, not ready-to-run G-code. There is no paired regular 3x project in this release;
use 3x-base.3mf and 3x-cap.3mf together with your own slicer settings.

Base prints floor-down and cap top-face-down, as exported. Print the coupon first.
Use both matching halves from this revision: base pillars and lid pads work together.
Keep antenna film and cables off the pillars; dry-fit before using the adhesive.
Check USB access, snap fit, BOOT and RESET action, and unintended button presses when
squeezing the closed case. Geometry/slicer checks do not validate every physical variant.
Install any magnet ring after printing and verify polarity before gluing. Compare
reception with the intended antenna placement; metal behind an antenna can affect it.

Guide and photos: https://wlancommander.com/sensors/esp32-c5/enclosure/
Checksums: SHA256SUMS.txt (all 25 individual 3MF files)